Industrial dryer daily use steps:
1. Before using the dryer every day, visually or manually touch the upper and lower sides, including heat exchanger air filter, dander filter and roller;
2. Open the steam inlet valve (open half), then open the bypass valve for 5-10 minutes. After the water in the pipeline and heat exchanger is drained, fully open the inlet valve and close the bypass valve.
3. Turn on the power, empty the machine and close the door. Adjust the heating and cold air for one minute each time, adjust the temperature to 45 °C, turn on the dryer, and use the 2 minutes to observe the running status of the machine (such as positive and negative, thermostat Whether to effectively control the heating solenoid valve, self-stop, etc.) and check the door switch;
4. The loading capacity should not exceed 70-80% of the design capacity of the washing machine.
5. Any flammable or odorous substances should not be placed in the dryer. Do not place any flammable, explosive, oxidizing, acid or alkali substances near the dryer;
6. During the operation of the industrial dryer, pay attention to its operating conditions, and if there is any accident, cut off the power supply and steam source immediately;
7. The dander filter should be diligently cleaned, usually 1-2 times for each towel. Must be cleaned before leaving work;
8. Do not open the door during the operation of the industrial dryer. Do not reach out to the machine to take the item before it is completely still. Items cannot be left in the machine overnight;
9. The heat exchanger is cleaned 2-3 times a week;
10. After the dryer is used every day, turn off the power and steam source. Check the motor and transmission system for abnormalities by visual or hand touch;
11. Clean and maintain the machine. The dryer is used every day, and the power supply and steam source are turned off.
Daily maintenance of industrial dryers:
1. Dust the surface of the machine every day to keep it bright and tidy.
2. Clean the dryer dust net at any time.
3. Check the running condition of the belt every day.
4. Clean the inner wall dust once a week.
5. The top heat exchanger filter is cleaned once a week.
6. Add butter to the motor motor every 15 days.