Vegetable washing machine use and maintenance adjustment notes

The vegetable washing machine is the impact of water and the bubbles inside to remove the stains inside, so don't worry if there will be other things inside. In general, when people wash vegetables, some people accidentally leave the remaining stains, pesticides or toxins in vegetables and fruits. The vegetable washing machine will not make such mistakes. The vegetable washing machine does not have to worry about the family members getting the pesticides. The stains ensure that the washing is clean without harming the skin surface of the fruits or vegetables, and the all-round cleaning stains are allowed. People who use it are assured.

Vegetable washing machine inspection:

* Step, check its pressure chain every day for 4 to 9 mm is the standard value.

The second step, remember to check the amount of oil every day, you must wait until the motor stops before checking.

The third step is to rub the machine itself up and down if it is not used for a long time. With a little oil, you can put it in a clean place.

Vegetable washing machine maintenance adjustment:

*, is the adjustment of the chain

The adjustment is made after the motor is stopped. The chain is pressed by the fingers in the middle of the two sprockets. The compression is generally between 4 and 9 mm, which is the standard value. When the standard value is exceeded, the idler is adjusted to the specified tightness. .

Second, the replacement for stepless speed change

The fuel supply and replacement of the gearless gearbox oil is first to stop the motor. It is strictly forbidden to remove the oil plug when the fireworks are exhausted. The oil just flows out to the appropriate amount. If it is insufficient, it should be replenished.

Third, the adjustment of the belt

After the motor is stopped, at the middle of the two pulleys, the compression amount of the belt (middle finger and index finger) is 7 to 12 mm as a standard value. When it is greater than the standard value, adjust the idler to the specified tightness.

Fourth, we don’t use it for a long time.

When we want to save for a long time without using it, we can clean and clean all parts of the earth, etc., and all the rotating parts and the attached objects such as belts and chains should be completely removed and the turning parts And rub the active part, fully oiled to prevent the occurrence of rust.