Small desktop capping machine operation and precautions

The small bench-topping machine is mainly used for rolling 5-500ml glass caps. When we use any of the bottle sizes, just put the bottle of this size on the tray, hold the cross arm in one hand, and screw the other hand. Loosen the nut on the left side of the cross arm to lower or raise the cross arm until the cap and the cap are about 18 mm. Tighten the nut. Then use the hex wrench with the belt to hold the ring against the cross arm and lock the ring. tight.
How to operate the V-arm of a small bench-topping machine:
In operation, we first put the bottle into the lower V-shaped bracket slot, then loosen the two screws on the V-shaped bracket slot, and move the bottle and the lower V-block together until the position of the cap and cap is correct. After that, tighten the two screws on the V-bracket slot.
Small bench rolling machine specific operation method:
Place the bottle filled with liquid and put on the lid onto the lower tray, rest on the V-shaped branch, hold the bottle with one hand, and pull the handle backwards with the other hand, then the tray lifts the bottle up. Until the cap is pressed against the cap. After the cap and the capping head are pressed, the three capping heads that are continuously rotated are rotated several times, and then the cap is rolled.
Push the handle forward so that the lid of the rolled lid is returned to the original position with the tray. The entire manipulating process is completed, and the above operation can be repeated each time a cap is rolled. Our small bench-top capping machine is equipped with a number of capping heads, which can be selected according to the size of different bottle caps to seal different sizes of glass caps.
Precautions for operation of small bench-topping machine 1. If the cover is not tightly rolled, unscrew the capping lock nut and turn the upper capping head counterclockwise, then lock the upper fixing nut.
2, the lid is rolled too tight, there is a phenomenon of rotating the cap. The upper capping lock nut can be unscrewed and screwed clockwise into the upper capping head, and then the upper retaining nut is locked.
3, the bottom of the bottle cap is not tight, the eccentricity of the three rolling heads can be adjusted according to the actual situation. If the collection is too tight, there is a phenomenon of crushing the bottle, and the eccentricity of the three rolling heads can be appropriately adjusted.