Lighting time. Flowers placed in shade in the summer, such as palm, brazilian iron, rubber tree, diviflora, Monstera, asparagus, etc. As sunlight falls gradually in autumn, they should be moved to morning and evening sunshine. Give 5 to 6 hours of light daily. At the same time, applying nitrogen-based nitrogen, phosphorus, and potassium fertilizers to the flowers in combination with the new high-fat membranes will not only enable flowers to thrive, but also increase the cold-resistance of flowers after winter.
nutrient content. Pay attention to increase the nutritional content of flowers. Chrysanthemum, waxberry, white magnolia, crab claw blue, Ruixiang, Paphiopedilum, etc. are all buds in the fall; while rose, Clivia and other long branches and leaves, and pregnant buds. At this time, attention should be paid to adding phosphorus-based nitrogen, phosphorus, and potassium fertilizers 2-3 times. Spraying the flowers, Zhuang Ti Ling, during flower buds can promote strong flower buds, hypertrophy of petals, bright colors, rich floral aromas, and prolonged flowering. Apply the above fertilizer 1-3 times a month.
Change land for pots. After entering the autumn, it is a good time to turn basins and change soil. All flowers with too small flowerpots and densely rooted basal walls should be replaced in time to facilitate the growth of flowers. Flowers that do not need to be changed should also be changed.
Pruning leaves. For budding chrysanthemums, buds should be peeled off and buds removed; for rose, flower pomegranate, milan, jasmine, bougainvillea, calendula, coral flower, etc., each flower should be trimmed after being cut, and then the anti-corrosion film should be applied immediately after trimming. Closed wounds heal quickly. Antifreeze, anti-virus intrusion, dissemination of antiseptic rot, prevention of overwintering pests inhabiting and breeding, prevention of rainwater pollution, prevention of large wounds chapped. Smear the surface of the tree to prevent sunburn. In autumn, some flowers appear dead branches and leaves. At this time, we should pay attention to cut off the dead branches and leaves of the flowers so that we can see them.
IT02S, is JRT new product in the early 2019, which is a single-point LiDAR sensor, also called tof distance sensor. With a micro size of 46x17x7mm, customers can widely use in many Laser Measurement Solutions. The lidar distance sensor can measure 12m short-range with high frequency up to 100hz. It's great for Unmanned Aerial Systems. If you need us send you data sheet and spec for this products, offering sample as well, pls tell us, thank you.
Accuracy
+/-8cm@ 0.1~3.5m
Measuring Unit
cm
Measuring Range (without Reflection)
0.1-12m
Measuring Time
0.1~3 seconds
Measuring Frequency
100 Hz
Laser Class
Class II
Laser Type
650nm, <1mw, red
Weight
About 5g
Voltage
DC2.5V~+3.5V
Serial Level
TTL 3.3V
Size
46*17*7mm
Operating Temperature
0-40 ℃ (32-104 ℉ )
Storage Temperature
-25~60 ℃ (-13~140 ℉)
IT02S Mini Tof Sensor Module Diagram
Parameters of IT02S:
IT02S – the High performance-price ratio measurement solution
* low power consumption of single transmit and single receive
* small size: 46*17*7mm
* low cost
* proffessional techinical support
2D Laser Distance Sensor,2D Lidar Sensors,Tof Lidar Distance Sensor, Flight Distance Sensor
Chengdu JRT Meter Technology Co., Ltd , https://www.irdistancesensor.com